Add Papers Marked0
Paper checked off!

Marked works

Viewed0

Viewed works

Shopping Cart0
Paper added to shopping cart!

Shopping Cart

Register Now

eKönyvtár library
FAQ
 

Great deal: today with a discount!

Regular price:
2 170 Ft
You save:
304 Ft
Discounted price*:
1 866 Ft
Purchase
Add to Wish List
ID number:446408
Author:
Evaluation:
Published: 22.05.2021.
Language: English
Level: College/University
Literature: n/a
References: Not used
Table of contents
Nr. Chapter  Page.
1.  Introduction    3
2.  Stalagmometric Method    3
2.1.  Research Question    3
2.2.  Variables List    3
2.3.  Controlling the Variables    4
2.4.  Materials List    4
2.5.  Procedure    4
2.6.  Diagram    4
2.7.  Raw Data    5
2.8.  Data Presentation    5
2.9.  Data Processing    6
2.10.  Evaluation    6
2.11.  Suggested Improvements    6
3.  Tensiometric Method    7
3.1.  Research Question    7
3.2.  Variables List    7
3.3.  Controlling the Variables    7
3.4.  Materials List    8
3.5.  Procedure    8
3.6.  Diagram    8
3.7.  Raw Data    8
3.8.  Data Presentation    9
3.9.  Data Processing    9
3.10.  Evaluation    10
3.11.  Suggested Improvements    10
4.  Conclusion    10
Extract

3.10. Evaluation
In general the method and apparatus worked well. However, there were some faults which were not stated in the original plan:
1. The readings of the dynamometer were hard register as the force required to detach the wire appeared on the dynamometer only for an instant.
2. The temperature of the water was not measured directly so the actual temperature might not have been 22°C.
3. Only two wires of different length were used in the experiment resulting in possible inaccuracies concerning the relationship between length and force.
3.11. Suggested Improvements
1. To deal with the first problem, the readings of the dynamometer could be filmed with a camera and after – the recording could be checked to see the results precisely.
2. To deal with the second problem, the temperature of the water could be measured by using a thermometer.
3. To deal with the third problem, more wires of different length could be used in the experiment.

4. Conclusion
The values of the surface tension coefficient of water at temperature 22°C found through experimentation are …

Author's comment
Editor's remarks
Load more similar papers

Send to email

Your name:

Enter an email address where the link will be sent:

Hi!
{Your name} suggests you to check out this eKönyvtár paper on „Determination of Surface Tension of Water”.

Link to paper:
https://eng.ekonyvtar.eu/w/446408

Send

Email has been sent

Choose Authorization Method

Email & Password

Email & Password

Wrong e-mail adress or password!
Log In

Forgot your password?

Facebook

Not registered yet?

Register and redeem free papers!

To receive free papers from eKönyvtár.com it is necessary to register. It's quick and will only take a few seconds.

If you have already registered, simply to access the free content.

Cancel Register